Explanation Of Functions/Terms Used; General - Selve i-Marki Control W Bedienungsanleitung

GB

Explanation of functions/terms used

Explanation of functions/terms used

General

Manual/automatic sliding switch
In the 'Man' sliding switch setting, only manual command controls
and alarm signals are carried out (e. g.: UP, STOP, DOWN by pres-
sing the relevant buttons and wind alarm).
In the 'Auto' sliding switch setting, automatic command controls
are carried out (e. g. sunshade function, time ...).
Alarm signal control light
When the alarm signal control light is illuminated, this indicates an
alarm signal. If there is a permanent switching signal at the group
control inputs for more than 5 seconds, it is an alarm signal.
Group control
Group control is the control of several drives at the same time.
Operating mode
You see the current wind and/or sunlight settings in the display.
OK button
Press the OK button to store the current values displayed. To
activate the test mode, press the OK button and hold for
5 seconds. In addition, the manual/automatic sliding switch must
be set to 'Auto'.
+/- buttons
The following operations are possible using the + and - buttons:
• Menu
• Auto mode
• + button
• - button
change value
request information
next automatic switching time
next automatic switching time
44