Inhaltsverzeichnis
Werbung
Verfügbare Sprachen
Verfügbare Sprachen
Work Lamp
The double grinder is equipped with a work lamp. With the gooseneck the
lamp can be adjusted to illuminate the grinding wheel as desired. The
illuminant is a 12 V 10 W bulb with bayonet cap.
Changing the Illuminant
Should the illuminant fail, replace it as shown in the figures below. Pull the
power plug before changing the illuminant.
Replacing the Grinding Wheels
1.
To replace the wheel, loosen the three Allen head screws on the outer
side of the hood and remove the outer part.
2.
Now loosen the main retaining nut of the stone with a suitable open end
or ring spanner.
3.
The treads on the left hand side are left hand treats; the nut is loosened
by turning clockwise. Be careful not to confuse the nuts when putting
them down. Hold the wheel in place to keep shaft and wheel from turning
and be able to loosen the nut.
4.
After the nut has been removed, the outer flange and the grinding wheel
with the paper liners can be pulled off the shaft.
Operation
Hold the socket
with
one
hand
and turn the bulb
cover by 180° and
pull it off.
Hold the
socket in place
12
Push
the
bulb
down and turn it
counter clockwise.
Werbung
Inhaltsverzeichnis
