3M PELTOR ComTacXPI MT20H682FB-series Bedienungsanleitung Seite 6

GB
3:3 Volume
The volume setting adjusts the level-dependent function for ambient sound. There are
four level settings and a silent mode. Silent mode is confirmed by a voice message. The
volume is limited to 82 dB(A).
3:4 Menu
Press and hold the [+] and [-] button for one second for the menu. To step through the
menu, press the [-] button briefly. The menu steps are listed below as 3:5-3:8. At each
menu step the [+] button is used to change the setting and, if available, step through the
available settings. A ghost voice message confirms each menu step, followed by the cur-
rent setting. Changes are also confirmed by a ghost voice message. After a few seconds
of no activity, the menu returns to volume mode. By pressing [+] and [-], the volume
setting can be instantly reached at any stage of the menu.
3:5 Equalizer
The equalizer adjusts the tone for the level-dependent function for ambient listening.
There are four level settings: Low, Normal, High and Extra High.
3:6 Microphone (only specific models)
The microphone setting is only used to switch between bone conduction microphone
and external microphone. "External" is used when a boom microphone is connected to
the external input jack.
3:7 Factory reset
Resets all menu settings to the factory default values. This setting needs to be confirmed
by pressing [+] when the ghost voice says "confirm factory reset".
3:8 Advanced settings
The advance settings menu includes the additional settings described in 3:9-3:14. The
advance settings menu steps are added to the normal menu steps when activated. It is
automatically de-activated when returning from the menu.
3:9 Release time
The release time setting adjusts the time before the limiter for the level-dependent func-
tion opens after activation. It is adjustable in two levels: Fast and Slow.
3:10 Balance
The balance setting adjusts the volume balance between the right and the left ear. There
are seven level settings: Center, Right/1, Right/2, Max right, Max left, Left/2, Left/1.
3:11 External input sensitivity
The external input sensitivity setting adjusts the attenuation of the input signal applied
on the headset cable input (A:10). There are three level settings: Low, Medium and
High. When set to Low the gain of the input signal applied on the external input is low,
and when set to High, the signal gain is high.
3:12 Bone conduction microphone volume (only specific models)
The bone conduction microphone volume setting only adjusts the volume from the bone
conduction microphone. The volume setting of the bone conduction microphone allows
the adjustment of the volume in 7 levels, "0" is low and "7" is high.
3:13 Warning signals
The warning signal setting disables/enables the warning signals "low battery" and "auto-
matic power off". When switched off, none of these warning signals will be heard.
3:14 Automatic power off
The automatic power off setting disables/enables the automatic power off function.
3:15 Ear-plug mode
The ear-plug mode increases the volumes of ambient sound and the external input by
6