Cleaning, Maintenance And Ordering Of Spare Parts; Disposal And Recycling - EINHELL GC-CG 7,2 Li Originalbetriebsanleitung

blade against the tool housing. Slot the hedge
cutter blade onto the guide pins (Fig. 6 /Item F).
Release the blade release mechanism. The blade
is locked in place.
7. Cleaning, maintenance and orde-
ring of spare parts
Remove the battery from the tool whenever you
carry out any work on the tool (e.g. changing the
blade, carrying out maintenance, etc.). Risk of
injury from dangerous moving parts!
7.1 Cleaning
•
Keep all safety devices, air vents and the
motor housing free of dirt and dust as far as
possible. Wipe the equipment with a clean
cloth or blow it with compressed air at low
pressure.
•
We recommend that you clean the device
immediately each time you have finished
using it.
•
Clean the equipment regularly with a moist
cloth and some soft soap. Do not use
cleaning agents or solvents; these could
attack the plastic parts of the equipment. En-
sure that no water can seep into the device.
•
A few drops of oil (e.g. sewing machine oil)
will improve the cutting performance of the
blades, but never apply any grease to the
blades.
•
To ensure constant exact cutting it is also
important to remove grass remnants and dirt
from between the upper and lower blade.
Caution!
Never clean the tool under running water
- and particularly never with high pressure -
because of the potential danger to persons
and property. Keep your cordless grass
cutter and hedge trimmer in a dry and frost-
proof place. Choose a place that children are
unable to enter.
7.2 Maintenance
•
To achieve good results you should keep the
blades sharp at all times. In particular we re-
commend that you immediately level off any
jags or ridges caused by stones or the like.
The tool should be thoroughly cleaned both
before and after use.
•
There are no parts inside the equipment
which require additional maintenance.
Anl_GC_CG_7_2_Li_SPK7.indb 18 Anl_GC_CG_7_2_Li_SPK7.indb 18
GB
7.3 Ordering replacement parts:
Please quote the following data when ordering
replacement parts:
•
Type of machine
•
Article number of the machine
•
Identification number of the machine
•
Replacement part number of the part required
For our latest prices and information please go to
www.isc-gmbh.info

8. Disposal and recycling

The unit is supplied in packaging to prevent its
being damaged in transit. This packaging is raw
material and can therefore be reused or can be
returned to the raw material system.
The unit and its accessories are made of various
types of material, such as metal and plastic. De-
fective components must be disposed of as spe-
cial waste. Ask your dealer or your local council.
- 18 -
05.09.2016 07:20:58 05.09.2016 07:20:58