Elektro-Automatik IF-U1 Benutzerhandbuch Seite 53

Index
1. General
1.1 Usage
1. The concept
1.3 Warranty/Repair
1.4 Used symbols
1.5 Scope of delivery
2. Technical specifications
3. Installation
3.1 After unpacking
3. Inserting a card
3.3 Combining interface cards
4. Details about the cards
4.1 RS3 cards IF-R1 and IF-R
4.1.1 Configuring the RS232 card
4. USB cards IF-U1 and IF-U
4.2.1 Configuring the USB card
4.3 CAN cards IF-C1 and IF-U
4.3.1 Configuring the CAN card
4.4 Analogue interface IF-A1
4.4.1 Pin assignment of the analogue interface (5-pole D-Sub socket)
4.4. General
4.4.3 Configuring the IF-A1
4.5 GPIB card IF-G1
4.5.1 Notes about the communication
4.5. Controlling a device via GPIB
4.5.3 Terms explained
4.5.4 Differences to the other interface cards
4.5.5 Firmware updates
4.5.6 Transmission and execution times
4.5.7 Configuring the IF-G1
4.5.8 SCPI commands and Delimiter
4.5.9 Errors
4.6 Ethernet cards IF-E1 and IF-E
4.6.1 Reset default parameters
4.6.2 Configuring the Ethernet card
4.6.3 Communicating with the device
4.6.4 The USB port / Firmware updates
4.6.5 The reset button
5. Operation in other device series
5.1 Electronic loads EL 3000 / EL 9000
5. Series PS 8000 T/ DT / U
5.3 Series PSI 800 R
6. The System Link Mode (only PSI9000)
6.1 Handling the System Link Mode
6.1.1 Display and handling of the master
6.1. Display of the slaves
6.1.3 Special alarms, warnings and signals
6. Configuration of the System Link Mode
© 009, Elektro-Automatik GmbH & Co. KG
EN
Page
55
55
55
55
55
55
56
57
57
57
57
57
58
58
58
58
58
59
60
60
61
61
64
64
64
64
64
64
64
64
65
74
75
75
75
75
76
76
77
77
77
77
78
78
78
78
79
79
53