Pilz PSS1 DIO T Bedienungsanleitung Seite 14

PSS(1) DIO T
• Neighbouring inputs should not be assigned to the same pulse.
• If the module is used as a pulse module, the inputs cannot be configured
for test pulses.
• Use copper wiring.
• Torque setting on the screw terminals should be 0.5 ... 0.6 Nm.
Faults
If a fault in one of the modules or a wiring error is detected, the controller
goes into STOP-condition, switches off all the outputs and sends a
message to the display. The display on the programmer's error stack can
be used to help locate the error.
4 Operating Manual