Herunterladen Diese Seite drucken

Thomashilfen RECARO Sport HERO Reha Montageanleitung Seite 7

Einbau des verlängerten 5-punkt-positionierungsgurtes (ece gruppe ii + iii, 18-36 kg)
Vorschau ausblenden Andere Handbücher für RECARO Sport HERO Reha:

Werbung

Verfügbare Sprachen

Verfügbare Sprachen

Using the extended 5-point positioning belt for large children (up to 36 kg /
79.4 lb)
The RECARO Sport HERO Reha child car seat has successfully passed a crash
test at Dekra (in Klettwitz) on the basis of the requirements of ECE R 44/04. The
RECARO Sport HERO Reha is therefore approved for use as a child restraint sys-
tem for special needs "S".
To enable your child to use the RECARO Sport HERO Reha for the longest pos-
sible time, the standard 5-point safety belt system, including the guide rail, can
be removed. This allows the headrest to be adjusted to a higher position. When
making this adjustment please observe the instructions contained in the original
RECARO Instructions for Installation and Use.
If it is intended to use a 5-point positioning belt for larger children, please ob-
serve the following installation instructions for the extended 5-point positioning
belt.
First remove the existing 5-point safety belt together with the guide rail (see the
notes in the original RECARO Instructions for Installation and Use). However,
do not completely remove the shoulder pad, but simply pull the guide rail out
from the shoulder pad's fastening straps.
Installation of the 5-point positioning belt is easier when the buckle tongues
are latched into the belt buckle. Thread the lap belts downwards from the top,
through the outer slots in the seat base, and then feed them through the inner
slots back to the top. Now insert the locking plates into the loops (fig. 2).
Next, feed the crotch strap through the slot in the seat base and secure the loop
on the end using the associated mounting plate. Now clip the base plate back
into position.
Thread the shoulder straps through the slots in the cushion and the seat shell
(fig. 3). The shoulder straps are now routed over the seat's body shell without
using the guide rail. Engage the shoulder straps into the T-section of the adjuster
strap fig. 4). Finally hook-and-loop-fasten the shoulder pads around the belts.
You can push the straps for fastening the shoulder pads to the guide rail into the
shoulder pad.
7

Werbung

loading