Midland BT Rider FM Anleitung Seite 12

Instruction guide
Thanks for purchasing the Midland BT Rider FM.
In this guide you will find all the information you may need to get the
best performances from this device.
The package contains:
• 1 Bluetooth main unit
• 1 clamp for helmet fixing
• 1 wall charger 230 V AC
• mounting kit: allen wrench, velcro and extension pads.
Bluetooth Headset
The unit allows the connection with a Bluetooth mobile phone, Bluetooth
transceiver (Midland 445 BT), Bluetooth adapter BPA 100 or navigation
units like Garmin Zumo or TOM TOM Rider.
2 Make sure that the main unit is fully charged prior to initial use.
Allow al least 4-5 hours for a full charge before using for the first
time.
2 The headset must be paired to another suitable Bluetooth device
before first use. This can be a cellular phone, transceiver or
navigation system with Bluetooth inside or via Bluertooth adapter
BPA 100.(refer to chapter "Pairing process" for further information).
2 The headset function uses the AGC technology, that automatically
increases the volume according to the background noise.
2 If the unit is paired to a cellular phone, just remember that the "voice
recognition answer" to incoming call is enabled by default (refer to
chapter "Voice recognition (VR)" for further information).
Technical specification
Technology ............................................................ Bluetooth® ver. 1.2
Maximum distance................................................................about 10m
Battery life in conversation ......................................................about 7h
Battery life in stand-by ................................................. about one week
Charging time ..................................................................... about 4-5h
IMPORTANT
MIDLAND BT Rider FM is a water-resistant device, designed for
safe use under rainy conditions. However, the headset is not
totally waterproof and it is not recommended under heavy rain
conditions.
In any event, the silicone cover protecting the charging socket
should always be tightly closed.