Important Safety Rules - Hendi 272602 Patio Heater Gebrauchsanweisung

Gas requirements
• The pressure regulator and hose assembly to be
used must conform to local standard codes.
• Never use a gas cylinder with a damaged body,
valve, collar, or foot ring.
• A dented or rusty gas tank may be hazardous and
should be checked out by a gas supplier.
• Never connect this appliance to an unregulated
gas source.
Connecting to a gas cylinder
• Recommend to use 9kg gas cylinder or refer to
your gas supplier for suitable gas cylinder.
• Refer to your gas supplier for instructions on the
use of your gas cylinder.
• Only change gas cylinders outdoors or in a well
ventilated area away from naked flames and any
other source of ignition.
• The gas cylinder must always be used in an up-
right position.

Important safety rules

For use outdoors or in amply ventilated areas.
An amply ventilated area must have a minimum of
25% of the surface area open.
The surface area is the sum of the walls surface.
The use of this appliance in enclosed areas can be
dangerous and is PROHIBITED.
Children and adults should be aware of the high op-
erating temperatures of areas above the post when
operating this heater. Children should be carefully
supervised when in the vicinity of the heater.
NEVER hang anything, including clothes or any oth-
er flammable items, on this heater.
DO NOT operate this heater unless it is fully assem-
bled with its reflector in place.
Respect the minimum clearances from combustible
materials.
The length of the gas hose may not exceed 1,5 me-
ters.
• When the appliance is not in use, turn the gas cyl-
inder OFF.
• Always perform a leak test on gas connections
whenever a cylinder is connected. If bubbles form
in the leak test solution, do not use. Never use a
flame to test for leaks.
• Close the heater control knob by turning fully
clockwise.
• Close the gas cylinder tap and then attach the reg-
ulator onto the gas cylinder.
• Tighten all connections firmly and with a spanner
where appropriate. The cylinder should be located
on the cylinder base.
• Check for leaks at all joints using soapy water. If
a leak is found, tighten the joint and then re-test.
Ceiling / Overhang
1 mtr
1 mtr
EN
9