Know Your Product; Operation; Prior To Initial Operation - Sparky SM 1236CES Plus Originalbetriebsanleitung

selecting a lambswool polishing pad.
Larger lambswool polishing pad extending
beyond the flexible backing pad presents a
laceration hazard and may cause snagging
or kickback.
Safety warnings specific for sanding
operations:
a) Do not use excessively oversized sand-
ing disc paper. follow manufacturer's
recommendations,
sanding paper. Larger sanding paper ex-
tending beyond the sanding pad presents
a laceration hazard and may cause snag-
ging, tearing of the disc or kickback.
Safety warnings specific for wire brush-
ing operations:
a) Be aware that wire bristles are thrown
by the brush even during ordinary op-
eration. Do not overstress the wires by ap-
plying excessive load to the brush. The wire
bristles can easily penetrate light clothing
and/or skin.
b) If the use of a guard is recommended for
wire brushing, do not allow any interfer-
ence of the wire wheel or brush with the
guard. Wire wheel or brush may expand in
diameter due to work load and centrifugal
forces.
V - Know your product
Before using the power tool, familiarize your-
self with all the operating features and safety
requirements.
Use the tool and accessories only for the ap-
plications intended. All other applications are
expressly ruled out.
1. Spindle
2. Spindle lock button
3. Thumbwheel for electronic speed
pre-selection
4. ON/OFF switch
5. Hook-and-loop flexible backing pad
ACCESSORIES TO BE USED WITH
THIS POWER TOOL
6. Side auxiliary handle
7. Flexible backing pad with support
flange and fixing flange
8. Support flange
9. Fixing flange
Original instructions
when selecting
10. Abrasive sheet (sandpaper)
11. Lambswool polishing pad
12. Pin spanner
13. Operating tool with flange and nut (cloth
wheel, sponge, felt wheel, wire brush)
14. Hook-and-loop operating tool (soft
intermediate disc, abrasive sheet,
sponge, felt wheel, lambswool polishing
pad)
VI - Operation
These power tools are supplied from single-
phase alternating current mains only. They are
double insulated according to EN 60745-1,
IEC 60745-1 and can be connected to grounded
or not grounded sockets. This power tool is ra-
dio suppressed in compliance with EMC Direc-
tive 2004/108/EC.
The basic use of this power tool is for sand-
ing plaster coated ceilings and walls, for sand-
ing smoothed drywalls and for removing paint,
wallpaper and adhesive remnants by means of
sandpaper.

PRIOR TO INITIAL OPERATION

▪ Make sure the power supply voltage corre-
sponds to the value indicated on the name
plate with technical data of the tool.
▪ Always check the position of ON/OFF switch.
The power tool must be connected to the
power supply socket only when this switch is
in OFF position. If the plug is connected to
a receptacle while the power switch is in the
ON position, the power tool will start operat-
ing immediately, which could cause a serious
accident.
▪ Make sure that the cord and the plug are in
order. If the replacement of the supply cord is
necessary, this has to be done by the manu-
facturer or his agent in order to avoid a safety
hazard.
WARNING: Always switch off and un-
plug the power tool prior to any adjustment,
servicing or maintenance.
▪ In case the work area is remote from the pow-
er source, use as short as practicable exten-
sion cord with proper cross-section.
▪ Check that the auxiliary handle is properly
mounted and reliably tightened.
7
EN