Solamagic S3 Montage- Und Gebrauchsanleitung Seite 23

2b. Installation, radiant heater S3
(Heater type IR 05008) with T-brackets
Heater type Power
IR 05008 2500 W
Step 1: Installing the T-brackts
• Install the S3 radiant heater using 2 T brackets at a separation of 400 mm while
observing the safety distances and safety instructions (see Appendix 2).
• Secure the T-bracket (1) with the silicone plate (2) below it on the fastening
surface with 2 screws each according to the following figure.
15
2 1
Step 2: Installing adapter claws on the T-brackets
• Push the adapter claws (6) into both T-brackets (1) mounted on the fastening
surface. Insert the M8x20/5 mm AF screws (8) into the holes. Insert the washer
(9) and tighten the M8/13 mm AF nuts (10).
Wall installation
Horizontal Vertical

8 6
9 10
23
Ceiling installation
Horizontal Inclined

08/2016