Solamagic S3 Montage- Und Gebrauchsanleitung Seite 22

2a. Installation, radiant heater S1
(Heater type IR 05001, IR 05002) with T-bracket
Heater type
IR 05001
IR 05002
Only approved for wall mounting!
• Secure the T-bracket (1) with the underlying silicone plate (2), while observing
the safety distances and safety instructions (see Appendix 2)
• Secure the T-bracket on the fastening surface with 2 screws according to the
following figure.
• Fit the adapter claw (6) on the T-bracket in accordance with the drawing, fit sa-
fety washers between the T-bracket and adapter claw and screw in M6 socket
cap screws from outside into the T-bracket.
• Push the securing lugs (3) with the ring (4) from the left side into the dovetail
groove
• Tighten the 3.5 x 6.5 screw (5).
• Attach the radiant heater S1 centrally on the adapter claw and adjust the poise.
• Use a 5 mm Allen key to tighten the eccentric tensioner (7)in a clockwise direc-
tion; each adapter claw must be firmly connected to the heater and free from
play.
• Fit each ring (4) of the securing lug into the cutout (A)
• To set or adjust the direction of radiation, use a 5 mm Allen key to loosen
the screws (11), shift the heater into the required direction and re-tighten the
screws (11).
08/2016
Wall installation
Power
Horizontal

1400 W

2000 W
B
3,4,5
22
Ceiling installation
Vertical Horizontal


11 6 7 A
Inclined
15
12 1 2