Descaling The Fresh Water Clip; Led Indicators - Jura IMPRESSA XJ5 Bedienungsanleitung

3 Descaling the fresh water clip

3 Descaling the fresh water clip

4 LED indicators

Mini hub
Fresh water clip
46
Calcium deposits may build up on the sensor of the fresh water clip.
We recommend descaling the sensor regularly. Use the same des-
caling solution that you used to descale the IMPRESSA.
T Close the shut-off valve.
T Disconnect the power supply to the valve block.
T Immerse the sensor in the descaling solution for about 20
minutes. Make sure the metal tabs are immersed in the liq-
uid.
T Remove the clip and rinse the sensor well under running
water.
E Calcium deposits may build up in the water tank. You should
therefore remove and clean the tank regularly.
Status LED for power supply (6)
U
On: No errors.
U
Off: Power supply interrupted or error (e.g. Mini hub not con-
nected to coffee machine, mains adapter not plugged in or
LED is defective).
U
Flashing: Valve block is active.
U
Flashing rapidly: Error.
Status LED on top of clip
U
White: No error, water level OK.
U
Flashing white: Valve block is active, no water detected.
U
Rapidly flashing white: Valve open.
U
Flashing orange: Error; water level too high or safety switch
inactive.
U
Off: Power supply interrupted or error (e.g. clip not connected
to Mini hub, mains adapter not plugged in or LED is defective).