About This Handbook; Product Description - AL-KO KHS 3704 Bedienungsanleitung

en
TRANSLATION OF THE ORIGINAL
OPERATING INSTRUCTIONS
Inhaltsverzeichnis
About this handbook........................................ 14
Product description.......................................... 14
Safety instructions............................................16
Assembly.......................................................... 16
Startup.............................................................. 17
Operation..........................................................17
Maintenance and care..................................... 18
Troubleshooting................................................19
Transport.......................................................... 19
Disposal............................................................19
Warranty........................................................... 20
EC DECLARATION OF CONFORMITTY........ 20

ABOUT THIS HANDBOOK

Read this documentation before starting up
the machine. This is a precondition for safe
working and flawless operation.
Observe the safety warnings in this docu-
mentation and on the product.
This documentation is a permanent integral
part of the product described and must be
passed on to the new owner if the product is
sold.
Explanation of symbols
CAUTION!
Following these safety warnings care-
fully can prevent personal injury and/or
material damage.
Special instructions for greater ease of
understanding and improved handling.

PRODUCT DESCRIPTION

Designated use
The log splitter is designed for private use in the
home and garden.
The log splitter is designed exclusively for the fol-
lowing applications:
Splitting freshly-cut timber that does not ex-
ceed the dimensions specified in the techni-
cal data.
14
Translation of the original operating instructions
Possible misuse
Splitting of timber containing metal compon-
ents such as nails, wire, metal braces, etc. is
prohibited
Operation in potentially-explosive atmosphe-
res is not permitted
Any other utilisation above or beyond correct
use is prohibited.
Safety and protective equipment
Motor circuit breaker
The motor circuit breaker switches the motor off
in the event of overloading of the log splitter.
The motor circuit breaker function should not be
deactivated.
Proceed as follows if the motor circuit breaker de-
activates the log splitter:
1 Disconnect the log splitter from the mains
power supply.
2 Remedy the cause of overloading.
3 Re-establish the power connection after allo-
wing the unit to cool for several minutes and
switch on the log splitter.
Connection cable
CAUTION!
Do not damage or sever the connection
cable.
Only rubber cable complying with the H07RN-F
quality standard stipulated in VDE 0282 Part 14
with a wire cross section of min. 2.5 mm² should
be used.
The max. permissible cable length is 10 m. A
longer cable impairs the motor performance and,
consequently, the function of the log splitter.
The connection cable, plug and connection socket
should be free of damage.
Repairs to the connection cable, plug and connec-
tion socket should only be realised by a specialist
electrical firm or workshop. A defective connec-
tion cable (e.g. with cracks, cuts or bends in the
insulation) should not be used.
Plug connections should not be exposed to damp
or water.
Proceed as follows in case of damage:
1 Disconnect the connection cable immediately
from the mains power supply
Electrical requirements
KHS 3700, KHS 5200 models
462706_i