VISUAL TruView Installations- Und Einrichtungsanleitung Seite 13

Click
5
On the Login screen, enter the username and password.
6
Click
7
The default username is root and the default password is calvin.
Configure the remote management card. Follow the instructions in
8
the server documentation.
Keyboard/Monitor Setup
Connect a keyboard and monitor to the Visual TruView server.
1
Turn on or restart the server.
2
When prompted, press Ctrl-E.
3
If the operating system starts before you press Ctrl-E, allow
the system to finish loading. Restart the system and then press
Ctrl-E.
Press the down arrow key to select NIC Selection.
4
Select Dedicated.
5
Configure the network controller LAN parameters to use DHCP or a
6
static IP address source. Do the following:
Press the down arrow key to select LAN Parameters.
a
Select IP Address Source.
b
Select DHCP or Static. If you select Static, configure the
c
Ethernet IP Address, Subnet Mask, and Default
Gateway settings.
Press Esc to exit.
d
Press Esc.
7
Select Save Changes and Exit.
8
The system automatically reboots.
Protect Your Network
•
Change default passwords.
After you connect and get the Visual TruView server up and
running, change the default username and password for
Microsoft Windows and the Server Administration account. It is a
security risk to continue to use published passwords.
•
Prevent unwanted access and reduce exposure by taking the
following precautions:
10
to acknowledge the security warning.
.