LaserLiner AutoSmart-Laser Bedienungsanleitung Seite 11

Laser modes
Rotary mode
The following speeds can be set using the rotary
button: 0, 150, 300, 600 rpm
Scan mode
The scan button can be used to activate and set
a lightintensive segment in 3 different widths.
You position the segment via the direction
buttons.
Hand receiver mode
Working with the laser receiver (available as an
optional extra): Set the rotary laser to maximum
speed and switch on the laser receiver. Refer to
the operating instructions for the respective laser
receiver about this.
Spot mode
You access spot mode by pressing the rotary
button repeatedly until the laser stops rotating.
The laser is turned into the required position
with the positioning buttons. The prism head
can be alternatively turned by hand.
EU directives and disposal
This device complies with all necessary standards for the
free movement of goods within the EU.
This product is an electric device and must be collected
separately for disposal according to the European Directive
on waste electrical and electronic equipment.
Further safety and supplementary notices at:
www.laserliner.com/info
AutoSmart-Laser
11
GB