Herunterladen Inhalt Inhalt Diese Seite drucken

Operation By Showme Button - Kindermann 7447000500 Installations- Und Bedienungsanleitung

Multiformat hdbt transceiver kaskadierbar in reihenschaltung (daisy chain)
Inhaltsverzeichnis

Werbung

Verfügbare Sprachen

Verfügbare Sprachen

In order to defi ne the parameters, fi rst insert the commands for ‚Power On' and for ‚Power Off ' into the
corresponding command lines, either using hexadecimal format or ASCII format. Next, specify if the
"end of line" code must be sent or not (Send CR / No CR, CR=Carriage Return). Using the ‚Timer/s' fi elds
an individual timeout between 0-9999 seconds can be assigned to both, the power-on and power-off
commands. Use the fi elds ‚Baud Rate' and ‚Data Bits' to set the communication parameters in accordance
to the display device used. Please refer to the user manual of your display device for all necessary
commands, syntax and parameters. ‚Stop Bits' and ‚Parity' can not be changed.
After entering all necessary parameters press ‚Selected Unit' to upload the command set to an individual
Quickselect 3.0+ that is connected to the display device via RS232. If identical display devices are
available for all participants that need to be controlled then the current command set can be uploaded
to all Quickselect units simultaneously by pressing ‚All Units'.
If several display devices coming from diff erent manufacturers are used, an individual command set
can be entered and uploaded to the corresponding Quickselect for each display device via ‚Selected Unit'.
Repeat the process as described above for each consecutive display device.
Note: After powering the unit it will automatically send a double „Power On" command. If no active source is
selected the unit will send „Power Off " after the timer delay.

8. Operation by ShowMe button

If the Quickselect units are installed in a way so that they are directly accessible by the user (e.g. sitting
on a tabletop) then each unit can be activated by simply pressing the ShowMe button on the front or
automatically upon automatic signal detection (see section about enabling 'Auto Show' mode using the
GUI software).
In case of a hidden installation each Quickselect units provides a set of connectors for three external
switch-keys with status LED feedback, to allow the user to directly select a specifi c input when the
connectors are extended, e.g. into a table connection plate.
Install the QuickSelect under the table with the mounting brackets so that the label points up; wire the
connection fi eld with the QuickSelect accordingly.
The rear ShowMe-connection acts like the integrated ShowMe-button. If only one source is connected,
the active input is automatically chosen when pushing the ShowMe button. Otherwise, the inputs are
switched through cyclically.
LED
GND
KEY
e. g. CablePort desk
for QuickSelect 3.0
2
Ref. No. 7430 000 008
NC
+
-
NO
C
33

Werbung

Kapitel

Inhaltsverzeichnis
loading

Diese Anleitung auch für:

Quickselect 3.0+

Inhaltsverzeichnis