Changing The Spool (09, 10); Storage; Help In Case Of Malfunction - AL-KO MULTITOOL MT 40 Betriebsanleitung

GB
7.1

Changing the spool (09, 10)

Replacement spool: Art. no. 113349, set of 2.
Precondition: The appliance must be switched off
and the rechargeable battery must be removed
from the basic appliance.
Inserting and pulling out the spool
1. Press (09/a) the two unlocking buttons (09/1)
at the same time and remove (09/b) the
cover (09/2).
2. Pull out (09/c) the empty spool (09/3).
3. Insert (10/a) the new spool (10/1). At the
same time, make sure that the spring is re-in-
serted.
4. Thread the cutting line (10/2) through the
openings (10/3) of the spool head towards
the outside.
5. Put on the cover (10/4) and press on until it
engages.
6. Insert the rechargeable battery in the basic
appliance.
Bring the cutting line to the required length
1. Switch on the appliance.
2. Tap (04/a) the spool head (04/1) on the
ground from time to time. This unwinds a
piece of new cutting line from the spool.
3. Switch off the appliance and wait until the
cutter head has come to a standstill.
4. Check the line length.
5. Repeat the previous steps until the cutting
line has the required length.

8 STORAGE

Thoroughly clean the appliance after each use
and – if present – attach all covers. Store the ap-
pliance in a dry, lockable place out of the reach of
children.
Carry out the following jobs before intervals in
work lasting for longer than 30 days:
■
Thoroughly clean the appliance and store it in
a dry place.
26

9 HELP IN CASE OF MALFUNCTION

CAUTION!
Risk of injury
Sharp-edged and moving
appliance parts can lead to
injury.
■
Always wear protective
gloves during mainten-
ance, care and cleaning
work.
Malfunc- Cause
tion
Additional Spool is
cutting line empty.
is not sup-
plied.
Re- Grass is too
chargeable long or too
battery op- wet.
erating time
is signific-
antly
Cutting
shorter.
height is too
low.
Motor run- Appliance
ning, but faults
the spool
does not
turn.
Appliance Spool is con-
vibrates un- taminated.
usually.
Appliance
faults
Other faults See "Multitool MT 40 – basic ap-
pliance" operating instructions.
NOTE
If you encounter any malfunctions that
are not listed in this table or that you
cannot rectify yourself, please contact
our customer service.
Storage
Remedy
Change the spool.
■
Cut the grass
at a greater
height.
■
Let the grass
dry.
Cut the grass at a
greater height.
Contact an AL-KO
service centre.
Clean the spool,
renew it if neces-
sary.
Contact an AL-KO
service centre.
GTA 4030