Operation Without Dmx Controller; Automatic Mode; Changing The Speed; Music Control - IMG STAGE LINE WASH-50LED Bedienungsanleitung

4) Use the button  or  to change the setting .
5) When submenu items are available: Call them
up with the button ENTER and then change
their settings with the button  or  .
6) Press the button ENTER to save a setting .
7) For additional settings, use the button MENU
to return to a higher menu level .
The menu will be automatically exited after a
few seconds if no button is pressed . Depending
on a menu setting, the display may extinguish
after a few more seconds (
be illuminated again when a button is pressed .
Refer to chapters 7 to 9 and make the desired
settings for the corresponding operating mode .
7 Operation without
DMX Controller
The unit provides four automatic show programs
that can also be run by music control . In addi-
tion, a manual mode is available .

7.1 Automatic mode

1) Call up the menu with the button MENU .
2) Select the menu item
 or  and then press ENTER to confirm .
3) Use the button  or  to select the show
program desired (
press ENTER to save it .
Notes:
Do not wait too long before pressing the next
button; the menu will be exited automatically
after a few seconds if no button is pressed .
If the automatic program fails to start and if
appears on the display, check the menu
☞
item ( chapter 7 .3) . The option
(Master) must be selected .
7.1.1

Changing the speed

To change the movement speed of the spotlight
head:
1) Call up the menu with the button MENU .
2) Select the menu item
 or  and then press ENTER to confirm .
3) Use the button  or  to select the speed
for the pan movement or the speed
☞
chapter 9 .3) . It will
with the button
... ) and then
with the button
for the tilt movement and then press
ENTER to confirm .
4) Use the button  or  to set the value de-
sired (0 – 9) and then press ENTER to save it .
7.1.2

Music control

The menu can be used to define if the move-
ments and colour changes of the automatic
programs are to be sound-dependent, i . e . in
sync with the music . In addition, it is possible
to change the sensitivity of the internal micro-
phone .
1) Call up the menu with the button MENU .
2) Select the menu item
 or  and then press ENTER to confirm .
3) Use the button  or  to switch music con-
trol on ( ) or off (
to confirm .
4) Select the menu item
 and then press ENTER to confirm .
5) Use the button  or  to set the microphone
sensitivity value desired (0 – 100) and then
press ENTER to save it .

7.2 Manual mode

In the manual mode, the head position, the col-
our mix, the total brightness and a stroboscope
effect can be set .
1) Call up the menu with the button MENU .
2) Select the menu item
 or  and then press ENTER to confirm .
3) Use the button  or  to select one of the
following parameters and then press ENTER
to confirm .
pan position
tilt position
red component
green component
blue component
white component
total brightness (dimmer)
stroboscope effect
the effect variants correspond to the
stroboscope channel for DMX con-
☞
trol ( chapter 11 .1 .2, channel 4)
4) Use the button  or  to set the value
desired (0 – 255) and then press ENTER to
save it .
with the button
) and then press ENTER
with the button
with the button
17