Safety Notes; Important Notes; Functions; Information About Operation - LGB 70500 Bedienungsanleitung

Safety Notes

• This locomotive is to be used with the operating system
designed for it.
• Use only switched mode power supply units and transfor-
mers that are designed for your local power system.
• This model may only be supplied with power from more
than one power pack.
• Pay close attention to the safety notes in the instructions
for your operating system.
• The wire used for feeder connections to the track may
only be a maximum of 2 meters / 78 inches long.
• Not for children under the age of 15.
• WARNING! Sharp edges and points required for operation.

Important Notes

• The operating instructions are a component part of the
product and must therefore be kept in a safe place as
well as included with the product, if the latter is given to
someone else.
• Please see your authorized LGB dealer for repairs or

spare parts.

• http://www.maerklin.com/en/imprint.html

Functions

• This model is designed for operation on LGB two-rail DC
systems with conventional LGB DC train controllers or
power packs (DC, 0 - 24 volts).
• Use a locomotive controller with more than 1 amp of train
current for this model.
8
Mode of Operation Switch
This model has a four-way power control switch mounted in
the cab (Fig. 1).
Pos. 0 All power off
Pos. 1 Power to motor and lights
Pos. 2 same as Position 1
Pos. 3 same as Position 1
Multi-Purpose Socket
The model has a "flat" multi-purpose socket, with a remova-
ble cover, on the rear wall of the cab (Fig. 2). These sockets
can be used to provide track power to cars with lighting or
sound electronics.
Multi-Train System
The model is equipped with a factory-installed onboard de-
coder for the LGB Multi-Train System. It can be used without
modifications on analog or digital layouts. For operation
with the Multi-Train System, the model is programmed to
loco address 03. For information on programming the loco
address, see the instructions for various MTS components.
If programming results in unsatisfactory operation, you can
reprogram the factory pre-set values of most important CVs:
Program register CV 55 to function value 55. To reprogram
the factory pre-set function values with the 55015, select
programming mode "P" (displays shows "P --"). Then input
6, 5, and 5 and press the right arrow button. The display
shows "P --" again: Input 5, 5, and 5 and press the right
arrow button again.