Live Mode - MADRIX Plexus Kurzanleitung

Live Mode

You can use this interface as a live controller to send DMX data via
®
MADRIX . You can either use 2x DMX-OUT, or 2x DMX-IN, or 1x DMX-OUT
and 1x DMX-IN, or Art-Net in Live Mode.
Please make sure to install the MADRIX
connect the PLEXUS directly to a free USB 2.0 port of your computer or use
the USB power supply (or USB 2.0) and the network connection for Art-Net.
®
If the MADRIX
will light up accordingly, as described on page 9. Start the MADRIX
software now if not yet done.
Configuration of the DMX-OUT or Art-Net functionality can be set up directly
®
in MADRIX using the 'Device Manager'. In MADRIX
'Preferences'
needed). Also remember to configure your virtual light matrix in the menu
'Preferences'
For more information, please read the user manuals.
Using MADRIX
You can use this interface to receive DMX data via MADRIX
please use a Male to Male 3-pin or 5-pin XLR Gender Changer if necessary.
Configuration of DMX input can be set up directly in MADRIX
In MADRIX ® , navigate to the menu 'Preferences'
select the tab 'DMX Devices'. Select your interface and activate 'Enable' as
well as 'Input' in the 'Settings' section. Press 'Apply'.
In the next step, configure your PLEXUS to control MADRIX
'Preferences'
(Universe 1 to 8), select your 'DMX-IN Device', and activate 'Remote'. Then,
choose one of the input protocols in the section 'Remote Control' and press
'Apply'. Close the window with 'OK'.
For more information, please read the user manuals.
14
PLEXUS driver has been installed properly, the status LEDs
'Device Manager'
'Matrix Generator' or 'Preferences'
®
PLEXUS As DMX-IN Interface
'Device Manager'
® software first. Afterwards, please
®
'DMX Devices', and
'DMX Input'. Choose an entry in the list
, navigate to the menu
'Art-Net' (if
'Patch'.
®
. For DMX-IN,
® .
'Device Manager' and
® remotely under
®