SPORTSTECH F26 Benutzerhandbuch Seite 19

Before completing an exercise session always:
1. Allow time to slow your cool down, reducing your heart rate to a normal level before completing
your workout.
2. Grasp the handlebar and press the slow speed key. Slow your pace to an easy walk.
3. Ensure the running belt has come to a complete stop before exiting the treadmill.
WARNING:
Turn off and unplug the treadmill before proceeding with any maintenance or visual inspections. Failure
to do so may result in serious injury. Note: Failure to perform the required periodic and preventative
maintenance can void your warranty.
AT THE END OF EVERY EXERCISE SESSION ALWAYS
1. Remove the Safety Key from the Console.
2. Use the Power Switch to turn the treadmill off.
3. Always position and store the Power Cord where it is clear from all pathways.
4. Unplug the Power Cord from the electrical outlet. This is especially important if you are not going to
use your treadmill for extended periods.
5. Wipe all treadmill surface with a dry cloth or towel especially perspiration on the handlebars, console,
running belt or other treadmill components.
STORAGE
●Store your treadmill in a clean and dry environment. Ensure the Power Switch is off and is unplugged
from the electrical outlet.
MOVING
●Check the Cylinder into the locked position before moving the treadmill.
●The treadmill has been designed and equipped with wheels for easy mobility. Before moving, ensure the
Power Switch is in the 'OFF' position and the power cord is unplugged from the electrical outlet.
Tilt the base frame of the treadmill and then roll the treadmill to the desired position.
LUBRICATION:
The treadmills have already been spread with "Silicone Oil" in advance before leaving the manufacturing plant.
Silicone oil is without volatility and has gradually permeated through the running belt.
Lubrication must be applied all 50 working hours.
NOTE: Only use "Silicone Oil" lubricants for this
equipment. In addition, do not add any other oil
ingredient; otherwise the treadmill will be damaged. Do
not over-lubricate the walking board. Excess lubricant
should be wiped off with a clean towel.