Battery Charging Instructions - Carson Reflex Stick Ultimate Touch 500501002 Betriebsanleitung

Charging the TX battery
1. Insert the TX battery in the compartment on
the underside of the remote control and close the
compartment again with the closure cover.
2. Connect the USB charger lead supplied to a USB
230V adapter (230V adapter is not included).
Warning!!!
Please always check before using your RC system
that the RX and TX batteries are fully charged;
otherwise you may lose control of your model.
Use only an appropriate charger for charging the
batteries, as otherwise the battery may overheat,
ignite or explode.
Always observe the safety instructions contained in
the manual.
CARSON Reflex Stick Ultimate Touch 500501002
3. The mini USB connecter must now be connected
to the USB port, which is located on the back of
the transmitter.
4. Next insert the USB 230V adapter into the socket.
Charging will now start. Alternatively, you can also
connect the USB charger lead to a computer.
Separate the charger lead from the transmitter once
the battery is fully charged. If you do not intend to
operate your RC system any longer, remove the TX
battery before storing.
GB
PC
77