Spoiler Function; Elevator To Flap Mix - Carson Reflex Stick Ultimate Touch 500501002 Betriebsanleitung

2.3 Spoiler function

Spoiler will be used when aircraft is landing. It is used to increase pressure
between aircraft and land so as to brake quickly.
Spoiler function can be used to adjust the proportion of the 2 spoilers'
end points. If the structure does not have spoiler or 2 spoiler linkage,
then there is no this function, and no icon will be displayed. The spoiler
function can be assigned to a switch (SwA-SwH) to enable and disable it,
or be assigned to a stick or a knob (All, Ele, Thro, Rud, VRA-VRE) to adjust
the value. This function can be set in 5 conditions respectively.
Select desired upside or downside and move the wheel to modify the
corresponding value.
For this example: The airplane structure has 2 spoilers. Setting the value
as the picture 22.3, in this situation the end points of the 2 spoilers are
80% and 75%.

2.4 Elevator to flap mix

When aircraft has elevator and flap ,elevator to flap
function is used to adjust the proportion of the
corresponding mix end point which default value
is 10%. The airplane can fly up or down, which
makes the flap move up or down accordingly. It is
commonly used for turning somersaults during
the flight. In most circumstances, the flap goes
down when the elevator goes up. lt is the pre-
programmed mix of elevator and flap. The position
of the corresponding channel is displayed in real
time. If the structure does not have Elevator or flap,
then this function is not available, and no icon will
be displayed. This function can be set in 5 conditions
respectively.
Touch the open button in the lower-left corner
to activate the elevator to flap function, Select
desired upside or downside and move the wheel
to modify the corresponding value. The function
can be assigned to a switch(SwA-SwH, LSw) to
enable and disable it. Touch the open button in
the lower-left corner to activate the elevator to flap
function. Touch the low side rate or high side rate
to set. Adjust the corresponding value by moving
the wheel. The function can be assigned to a switch
(SWA-SwH, LSw).
For example: Elevator to flap – function is activated.
Pic 22.4 The elevator to the topside
Pic 22.5 The elevator to the bottom
CARSON Reflex Stick Ultimate Touch 500501002
Pic. 22.03
Pic. 22.04 Pic. 22.05
GB
121