Problem Solving - Carson Reflex Stick Ultimate Touch 500501002 Betriebsanleitung

5.0 Problem solving

GB
1. Transmitter does not start up.
• The battery is not properly installed.
• Battery is empty.
• The screen flashes when the transmitter is
powered on, and then the transmitter turn itself
off immediately. It indicates the electric quantity
can´t support system for a long time and the
transmitter will be turned off once it is powered
on.
• The battery shrapnel is oxidized and loose
contact.
2. Remote control distance is not enough.
• The wrong position of transmitter antenna or
receive antenna.
• Nearby radio interference.
• Battery is empty.
• Obstacle screens off part of the signal.
3. The transmitter can´t control the receiver.
• The transmitter or receiver enters into the bound
status by accident. The problem can be solved
by powering on again or binding again if
necessary.
130 CARSON Reflex Stick Ultimate Touch 500501002
4. The transmitter may not accept the data sent by
the receiver sometimes when many models in
the air at the same time.
• The distance between two transmitters is too
close. Please keep more than 5 meters as far as
possible.
5. The item number of acquisition module does not
appear in the transmitter screen.
• The data cable of acquisition module is
connected to the wrong places.
• The plug of data cable is damaged.
6. The unstable data of speed acquisition.
• The position of speed sensor is not proper, which
drifts too far.
7. The simulator can not be checked on the
computer.
• The USB simulator function of transmitter is not
activated.