Technical Data; Declaration Of Conformity - Bosch Cutter Originalbetriebsanleitung

OBJ_BUCH-2057-003.book Page 18 Thursday, January 29, 2015 9:39 AM
18 | English

Technical Data

Cutting adapter
Article number
Weight, approx.

Declaration of Conformity

We declare under our sole responsibility that the product described un-
der "Technical Data" complies with all applicable provisions of the direc-
tive 2006/42/EC including its amendments.
Technical file (2006/42/EC) at:
Robert Bosch GmbH, PT/ETM9,
70764 Leinfelden-Echterdingen, GERMANY
Henk Becker
Executive Vice President
Engineering
Robert Bosch GmbH, Power Tools Division
70764 Leinfelden-Echterdingen, GERMANY
Leinfelden, 17.11.2014
Assembly
 Before any work on the screwdriver with cutting adapter (e.g.
maintenance, tool change, etc.) as well as during transport and
storage, set the rotational direction switch to the middle position.
There is danger of injury when unintentionally actuating the On/Off
switch.
Attaching the Cutting Adapter (see figures A1 – A2)
– You have to pull the rubber cap 9 of the screwdriver off toward the
front before mounting the cutting adapter 1.
– Then attach the cutting adapter to the screwdriver.
The cutting adapter must audibly engage.
Note: You can attach the cutting adapter in 8 different positions. This en-
ables you to achieve the optimum work position, e.g. for cutting a floor
covering along a wall.
1 609 92A 10G | (29.1.15)
kg
Helmut Heinzelmann
Head of Product Certification
PT/ETM9
Cutter
1 600 A00 1YN
0.15
Bosch Power Tools