Axis 232D+ Installationshandbuch Seite 4

Page 4
Hard Ceiling Mount
Control
button
Network
connector
Connection
module
connector
Power
Indicator
Network
Indicator
Referring to the image above, follow these instructions to mount the dome camera:
1. Using the supplied drill template, drill three holes in the ceiling and secure the bracket to the ceiling with
three screws.
2. Slide the decoration ring and cover ring on to the AXIS 231D+/232D+.
3. Insert the fixing screw holder into the mounting slot.
4. Connect the connection module cable to the connection module.
5. Connect the Ethernet cable and connection module to the AXIS
231D+/232D+.
6. Connect the power cable (24V AC) to the connection module and
check that the power and network LEDs light up green.
7. Mount the dome body onto the bracket and rotate it clockwise.
Make sure the screw hole on the side of dome is aligned with the
bracket. Tighten the fixing screw to secure the dome.
8. Attach and secure the cover ring and decoration ring to the
bracket.
9. The hardware installation is now complete, proceed to Assign an IP
address, on page 7 to install the AXIS 231D+/232D+ on your
network.
Rear view
Serial number
S/N
Mounting slot for
fixing screw
AXIS 231D+/232D+ Installation Guide
Cover ring
Ceiling
bracket
Decoration
ring
Connection module
PS GND
24V AC
Connection module cable connector
Side view