Before Using The Appliance; Operation; Cooling - Technibel MTF 73 Bedienungsanleitung

BEFORE USING THE APPLIANCE

Check that the power supply at the location where the air conditioner is going to be
G
used is 220-240V ~ 50Hz .
Do not move the air conditioner without controlling (through the tank access door
G
on the back of the unit) the eventually condensate water inside it.
Make sure that the electrical installation is suitable to supply continuously current
G
necessary for the air conditioner in addition to that already used by other electric
appliances (white goods, lighting). See the max electric input indicated on the
name plate positioned on the air conditioner.
The installation of a double-pole switch, protected by 10 A fuses of the delayed
G
type, upstream the electricity wall socket, is recommended.
The unit has to be connected according to the local electrical rules.
G
Make sure that circuit breakers, fuses, etc, are of sufficient capacity to handle a
G
start-up current of 18 A (generally less then 1 second).
Do not install the air conditioner where it could be wetted by drops of water (i.e. in
G
laundries).
Make sure that the ON - OFF push-button switch on the control panel of the air
G
conditioner is in OFF position (released).
Before connecting the air conditioner to a power socket, make sure that the socket
G
is provided with an earth connection in compliance with local codes.
Never use the power plug as a mean to start or stop the air conditioner: always
G
use the ON/OFF push-button switch on the air conditioner control panel.
WARNING! Do not stick anything into the air outlet of the air conditioner. This is
G
very dangerous because the fan is rotating at high speed.
WARNING!
G
Wait at least three minutes after each previous stop of compressor before re-starting
the unit. Several stops and re-starting in a short time could damage the compressor.
So avoid quick movements of the thermostat cursor in both directions and quick
pressing of the ON/OFF push-button switch when compressor is running.
Make sure that there are no obstacles around the unit affecting the free circulation
G
of air. Do not block the air intake (keep a minimum free area of 25 cm) and outlet
of the unit with curtains or other. Never put objects on the top of the unit.
In order to obtain the maximum efficiency of the air conditioner, the flexible tube
G
should be retracted, without bends and without the outlet nozzle.
The manufacturer assumes no responsibilities if the safety regulations or local
G
codes are not observed.
WARNING
Always unplug the unit from the power socket before moving or cleaning it.

OPERATION

COOLING

G
Place the air conditioner as near as possible to the window. Fit the flexible tube by
hooking it to the rear of the unit. Extend the flexible tube just enough to reach the
outdoor, passing under the window shutters set ajar.
G
Open the window and lock one of the shutters. Place the outlet nozzle between the
two shutters, held together with the supplied lace.
G
Avoid sharp bends or plies of the flexible tube.
G
In case of porthole utilise make a 138 mm diameter hole in the window pane.
G
Twist the knob (3) of the thermostat to the right until you reach the position of max-
imum cooling.
G
Switch on the air conditioner pressing the ON/OFF push-button (1)
G
Press the push-button (2)
G
When room temperature has reached the most suitable value for your comfort,
press again the push-button (2) to select the low fan speed.
G
Now slowly twist the thermostat knob back towards the left until the compressor
stops.
At this point the air conditioner is set for automatic operation under the control of
the electronic thermostat to maintain the room temperature at the pre-set value.
G
To stop the air conditioner press again the ON/OFF push-button. (1).
to select the high fan speed.
.
EG
NO!
3