Operation - Hama RC 650 Bedienungsanleitung

5. Operation

5.1 Automatic time setting using the DCF signal
• Once you have removed the contact breaker, an acoustic signal sounds and the
alarm clock automatically starts searching for a DCF signal. During the search, the
radio icon (2) will flash.
• After 5-10 minutes (depending on how quickly the radio signal is received), the
clock sets itself to the correct time.
• When the wireless signal is received, the date, time, weekday and temperature are
automatically set and the radio icon (2) is displayed.
• If the clock is unable to receive a time signal wirelessly, the time/weekday/
temperature are displayed and the radio icon (2) is not visible. In this case, you
can set the time manually.
Display
Display flashing
Displayed continuously
Not displayed
5.2 Manual setting
Manually setting the date/time/calendar
• Press and hold the Down (10) button for approx. 3 seconds to stop the search for
the DCF signal. The radio icon (2) goes out and you can set the time manually.
• Press and hold the SET button (9) for approx. 3 seconds to start manually setting
the date/time.
• Set the following information in the order listed:
• To select the individual values, press the UP (8) button or the Down (10) button
and confirm each selection by pressing the SET button (9).
4
Searching for the DCF signal
Active
Successful – signal is being received
Deactivated