Introduction; General Comments; Manufacturer; Safety Instructions - Cillit Access 10 Einbau- Und Bedienungsanleitung

EN

1. Introduction

1.1 General comments

Please read this manual carefully and famliari-
se yourself with the operating instructions before
using this equipment.
Models covered by this manual:
Cillit Access for the device types:
®
• 10 / 10 Bio
• 15 / 15 Bio
• 20 / 20 Bio
• 25 / 25 Bio
The local standards as well as technical specifi ca-
tions have to be observed.
The operating instructions must be read in
conjunction with any national regulations con-
cerning accident prevention and environmental
protection.
Prior to putting the device into operation, read the
operating instructions completely and thoroughly.
Please keep this manual close to hand for quick
reference to the unit's operation.
The device shall only be used for its intended pur-
pose, in line with the operating instructions and
only in the environment to which intended.
Note: Never exceed the defi ned maintenance and
service intervals.

1.2 Manufacturer

BWT UK Ltd.
Coronation Road, BWT House
High Wycombe
Buckinghamshire, HP12, 3SU
Phone: +44 / 1494 / 838 100
Fax: +44 / 1494 / 838 101
E-mail: info@bwt-uk.co.uk
4
OPM - Cillit Access 10-25 vOrange - EN, DEv4.indd 4-5

1.3 Safety instructions

Danger caused by electric current or
voltage!
Always consult a qualifi ed electrician
when working on places denoted by this
symbol.
The complete power supply unit must be replaced
in the event of damage to the mains cable.
Warning:
Do not use any aggressive cleaning
agents!
If a power failure occurs when regeneration waste
water and overfl ow are being drained into a
sump, fl ooding may occur.
Please observe:
Use only trained or instructed staff.
Stipulate clear staff responsibilities
for operation, set-up, maintenance
and repair work.
Please observe:
NEVER operate the device with the
housing covers removed.
Note:
If needed use protective clothing.
Note:
Additional information for the
operator.

1.4 Intended use

The domestic application Cillit Access is desig-
®
ned for softening or partially softening domestic
water (in accordance with the relevant regulati-
ons.) All other use is strictly forbidden and your
own responsibility.

1.5 Scope of delivery

Cillit ® Access water softer with:
Standard delivery:
1. Multi-way control valve with
microprocessor controller
2. Blending valve
3. Softening column with ion exchange resin
4. Softened water outlet
5. Hard water inlet
6. Drain water
7. Overfl ow connection
8. Mains plug power supply connection
9. Operating manual
10. Hose clamp connection
11. 2 m drain water hose
12. Cover with short user instructions
13. AQUATEST hardness tester
Please open the cover (12), (See page 9):
14. Salt storage
15. Cabinet
16. Fixing material (See page 9)
17. Rating plate and
serial number (See page 9)
Additional delivery:
18. Non-return valve BSP: ¾" (DN: 20/20)
9
Cillit ® Access
Domestic water softener
10, 15, 20, 25
Weichwasseranlage
10, 15, 20, 25
Fitting and operating
instructions EN
Einbau- und
Bedienungsanleitung DE
Important notice: Always keep the fitting and operating instructions close
at hand to avoid any mistakes and before carrying out any work on the
device you should read the fitting and operating instructions carefully and
the best of our knowledge, the content thereof is not legally binding. follow them. While our data sheets and brochures should provide advice to
Changes of technical details are reserved!
Wichtige Hinweise: Um Fehler zu vermeiden, ist die Einbau- und Bedie-
nungsanleitung stets griffbereit aufzubewahren, vor der Ausführung von Ar-
beiten am Gerät vollständig durchzulesen und zu beachten. Unsere Merk-
blätter und Druckschriften sollen nach bestem Wissen beraten, der Inhalt ist
jedoch ohne Rechtsverbindlichkeit. Im Übrigen gelten unsere allgemeinen
Geschäftsbedingungen.
Änderungen bei technischen Details sind vorbehalten!
Cillit-GD 03-10001 / Rev. 1.02 – EN, DE / CIL10-25 / 2011-11
BWT UK Ltd.
18
8 11
10
13
1
12
14
15
12
4
5
6
2
7
3
02/10/2012 09:48
EN
5