Setting And Starting A Programme - Electrolux ESF6210LOX Benutzerinformation

6.1 Using the detergent
D A B
30
20
A B D
3 0
2 0
6.2 Using the combi detergent
tablets
When you use tablets, that contain salt
and rinse aid, do not fill the salt container
and the rinse aid dispenser. The rinse aid
indicator always comes on if the rinse aid
dispenser is empty.
1. Adjust the water softener to the lowest
level.
2. Set the rinse aid dispenser to the low-
est position.
If you stop to use the combi
detergent tablets, before you
start to use separately
detergent, rinse aid and
dishwasher salt, do these steps:
1. Press the on/off button to activate the
appliance.
2. Set the water softener to the highest
level.
3. Make sure that the salt container and
the rinse aid dispenser are full.
1.
2.
3.
4.
C
5.
A
-
+
C
Press the release button (B) to open
the lid (C).
Put the detergent in the compartment
(A) .
If the programme has a prewash
phase, put a small quantity of deter-
gent in the compartment (D).
If you use detergent tablets, put the
tablet in the compartment (A).
Close the lid. Make sure that the re-
lease button locks into position.
4. Start the shortest programme with a
rinsing phase, without detergent and
without dishes.
5. Adjust the water softener to the water
hardness in your area.
6. Adjust the released quantity of rinse
aid.
6.3 Setting and starting a
programme
Starting a programme without
delay start
1. Open the water tap.
2. Close the appliance door.
3. Turn the knob until the programme
marker is aligned with the symbol of
the programme you want to set.
• The on/off indicator comes on.
4. Press Start to start the programme.
• The Start indicator comes on.
• The washing phase indicator comes
on.
ENGLISH 25