Werbung
Verfügbare Sprachen
Verfügbare Sprachen
GB
16.0 Adjustment of the return spring tension
Attention! Disconnect the machine from the electrical supply.
The flange (2) must be held by means of a pin spanner and the screw (6) loosened with an 8 mm allen key.
The force of the spring is increased by rotation of the flange clockwise or decreased by rotation anti clockwise.
Tighten screw (6). (see figure 8)
18.0 Tool change
For the change of drills or other clamping tools a tool drift/ejector as per DIN 317 is needed. This drift is put in the
spindle slot. Release the tool with soft hammer strokes.
Attention: Do not push the spindle to its top position while the drift is inserted in the spindle slot!
For reasons of tool protection remove it by hand, otherwise the impact on the vice or table might cause a damage.
19.0 Care reference
For cleaning each standard cleaning agent for plastic is suitable.
9
112391 D/GB
Werbung
