Flott e1 Bedienungsanleitung Seite 8

GB
4.0 Transport
ATTENTION! Always check delivery for completeness and damage! The carrier (forwarder or railway) is to be
informed immediately in case of transport damages. (s. yellow leaflet)
5.0 Setting up the machine
The drill should be set up on a solid base and aligned using a spirit level. If the machine is to be bolted to the base,
it should be ensured that the base plate does not warp in the process. It is to recommend to use of vibration
damping elements.
6.0 Installation
The machine has been installed ready for use. Please check whether type of current, current voltage and fusing
agree with the prescribed values. There must be a protective earth terminal. Mains fusing 10 A.
Attention! Take notice of the right rotation (right-hand) of spindle.
7.0 Commissioning
The parts with rust-inhibiting coating should be cleaned carefully. The column should then be lubricated. The head
should be moved several times since condensation may have formed in the head guide.
8.0 Operating and indication elements (max. equipment) see figure 1
2. emergency push button
3.main switch
4.polarity/reverse switch
9.0 Operating
For starting/stopping the machine switch on/off the main switch. The electrical drill guard must be closed (safe
position). If present use the polarity/reverse switch to select the right speed level, now you can change from
spindle speed step 1 (right-hand) into spindle speed step 1 (left-hand) e.g. for tapping.
The switch drilling/tapping (option) selects the direction of the spindle, with the switch drilling/tapping (option)
choose the working process.
10.0 Speed indication
10.1 On machines without a digital speed indication the set speed will be shown on a scale at the shifting lever.
10.2 On machines with a digital speed indication the set speed will be shown exactly on the frontplate.
11.0 Speed change
11.1 On machines with a variable - speed drive open the hood, untension the belt with the tension pulley and
move the belt to the required speed. Tension the belt and close the hood.
11.2 On machines with a mechanical infinitely variable - speed drive change the speed by swivelling the shifting
lever when the machine is running.
12.0 Drilling depth indication
12.1 On machines without a digital drilling depth indication the drilling depth is shown on a scale.
12.2 On machines with a digital drilling depth indication the set drilling depth is shown digital.
13.0 Adjusting the drilling depth
On machines without a digital depth indication pull the limit stop (6) axially to the right, select the drilling depth and
push the limit stop (6) to the left. (see figure 1)
14.0 Feed
Manual feed is activated by the drilling lever which acts on the pinion shaft.
15.0 Adjustment of table
15.1 On machines without a rack untension the clamping lever, position the drilling table and tension the clamping
lever.Attention! Secure the table against falling.
15.2 On machines with a rack untension the clamping lever, adjust the table height by means of the hand crank
and tension the clamping lever
8
112391 D/GB