Werbung
Verfügbare Sprachen
Verfügbare Sprachen
Initial use
For a start, please clean all accessory parts with warm water. Do not immerse the
water container (17) or the power base (19) in water in the process.
On initial use, it is recommended, for hygienic reasons, that you should prepare one
batch of espresso and then discard it.
The appliance comes delivered with the power cable (20) wound up inside the cable
storage on the power base's (19) underside. You may take it out depending on the
length that is needed.
Take care that the cable runs through the opening provided in the power base to
guarantee an even surface for standing.
Only operate the appliance on a stable and even surface and make sure that the cable
does not hang over the surface's edge.
Fill water container with water only. On no account must it be filled with coffee, milk or
other liquids. When filling it please take care that no water is dropped on the power
base (19) or the underside of the water container (17).
Caution:
If water container is overfilled, boiling cappuccino/espresso may be ejected!
Preparing CAPPUCCINO (3 cups)
Important: Initially, fix the cappuccino nozzle (see drawing) onto the pipe (4) inside the
jug's upper vessel (11) by screwing it on clockwise till tight. Then slightly press down
the small reset button (2) on top of the cappuccino nozzle. Attention: The reset button
must be movable; should it get stuck, make sure to clean nozzle with hot water for a
start.
The following instructions are based on the typical cappuccino involving a 1:3 mixing
ratio of espresso and milk. You may vary it to your personal taste, but bear in mind not
to exceed the maximum filling quantity of 500 ml.
10
Werbung
