Automatic Temperature Controler; Rating Plate; Operation And Handing - Caso W1800 Original Bedienungsanleitung

13.2 Automatic temperature controler

pushed or be shaken.
Only use the automatic temperature controler which has been
supplied with the appliance. Never use a different controller.
When removing and inserting the temperature controler push
the lever.
When connecting the automatic temperature controler make
sure that it has been plugged in correctly. Do not pull the cable but the plug of the
temperature controller. Do not handle with exaggerated force or bend.
Always keep the temperature controller and the pin of the holder clean.
Always turn the controler before removing and inserting to the
starting point of the arrow
overheating or failure.
Insert the automatic temperature controller in the connector "A".
If the temperature controller isn't fixed properly, a very high
temperature can arise which can cause injuries or damages to the appliance. Please
ensure that the temperature controller is plugged in correctly.
Immediately stop using the automatic temperature controller in case it is damaged or
overheated. Do not repair by yourself. Take the appliance to the next authorised dealer
and have it repaired.
The temperature controler should not be come into contact with the device! Always
removce the plug from outlet, then remove temperature controler.

13.2.1 Rating plate

The rating plate with the connection and performance data can be founded on the back of
the device.
14

Operation and Handing

This chapter provides you with important notices with regard to operating the device.
Observe the following notices to avoid dangers and damages:
Warning
► Do not leave the device unsupervised when it is in operation and remove the plug from
the socket after use.
1 temperature sensor
2 electric plug
3 electric cable
4 temperature regulator
The automatic temperature controler is a
highly sensitive part. Therefore, it is advisable
to make sure that it does not fall down, be
as it may otherwise lead to
27