Replacing The Lamp - AEG SKS58200F0 Benutzerinformation

Problem
Water flows on the
ground.
The temperature in
the appliance is too
low.
The temperature in
the appliance is too
high.

8.1 Replacing the lamp

8.2 Closing the door
1. Clean the door gaskets.
2.
If necessary, adjust the door. Refer
to "Installation".
Possible cause
Products prevent that wa-
ter flows into the water
collector.
There is too much water
in the air deflector.
The temperature regula-
tor is not set correctly.
The temperature regula-
tor is not set correctly.
The door is not closed
correctly.
The product temperature
is too high.
Many products are stored
at the same time.
There is no cold air circu-
lation in the appliance.
1.
2.
3.
4.
5.
6.
7.
8.
3.
Solution
Make sure that products
do not touch the rear
plate.
Clean the air deflector.
Set a higher temperature.
Set a lower temperature.
Refer to "Closing the
door".
Let the product tempera-
ture decrease to room
temperature before stor-
age.
Store less products at the
same time.
Make sure that there is
cold air circulation in the
appliance.
Disconnect the mains plug from the
mains socket.
Remove the screw from the lamp
cover.
Remove the lamp cover (refer to the
illustration).
Replace the used lamp with a new
lamp of the same power and specifi-
cally designed for household appli-
ances. (the maximum power is
shown on the lamp cover).
Install the lamp cover.
Tighten the screw to the lamp cover.
Connect the mains plug to the mains
socket.
Open the door. Make sure that the
lamp comes on.
If necessary, replace the defective
door gaskets. Contact the Service
Center.
ENGLISH
25