Operation - Smeg KDR 35 X Montageanweisung Und Gebrauchsanweisung

Description of the hood
Fig. 1
1. Control panel
2. Grease filter
3. Grease filter release handle
4. Halogen lamp
5. Vapour screen
6. Telescopic chimney
7. Air outlet (used for filter version only)

Operation

Use the high suction speed in cases of concentrated kitchen
vapours. It is recommended that the cooker hood suction is
switched on for 5 minutes prior to cooking and to leave in
operation during cooking and for another 15 minutes
approximately after terminating cooking.
Model with switch-board having 6 push-buttons
1. Switch
press to switch on/off lights.
2. Switch OFF suction / ON speed
(rating) of suction speed 1:
press this switch once turn off the
speed (rating) of suction function
that has been selected or (if no
speed rating of suction function
select the speed (rating) of suction
speed 1, press again and keep
pressed to activate the time-
function for 20 minutes (blinking
light), following this the cooker
hood will swittch off.
3. Speed selecting button suction
speed 2: press this switch once to
select the speed rating of suction
speed, press again and keep
pressed to activate the time-
function for 15 minutes (blinking
light) following this the cooker-
hood will switch off.
4. Speed selecting button suction
speed 3: press this switch once to
select the speed rating of suction
speed, press again and keep
pressed to activate the time-
function for 10 minutes (blinking
light) following this the cooker-
hood will switch off..
5. Speed selecting button (speed
rating) for intensive suction
(with timer): press to select the
suction-speed
functioning-time is 5 minutes
ON/OFF Pilot-lights:
(rating) , the
(blinking push-button) , following
this the suction function will either
turn off or return to the suction-
speed that had previously been
selected.
Note: It is possible to keep a
check of this function so that the
hood switches off 5 minutes after it
has worked, (even though another
function had been selected prior to
this one) after having pressed the
button, press again and keep
pressed , the pilot-light will start
blinking indicating that the selected
function has been set..
6. Reset Button for saturation of
filters: the hood will warn the user
that it is time to do maintenance
work on the filters, by giving out a
light-signal.
Red-light Button blinking: carry
out the maintenance of the greasy
filters, following this press the
button for over 3 seconds and the
button will turn off.
Red-light
maintenace on
following this press the button for
more than 3 seconds, the button
will switch off.
Attention: the hood is provided
only with a warning signal for
greasy filters.
To put into function the greasy-
filter signal:: Set the cooker-hood
off, press switch button no.6 for
more than 3 seconds ( the switch
will turn on red signalling that the
function has been set.
To disactivate the carbon filter
signal, repeat the entire procedure
again.
17
Button: carry out
carbon-filters,