Operation; Stand Alone-Mode; Sound Control; Automatic - EuroLite LED FE-800 RGBAW DMX Bedienungsanleitung

The earth has to be connected!
If the device will be directly connected with the local power supply network, a disconnection switch with a
minimum opening of 3 mm at every pole has to be included in the permanent electrical installation.
The device must only be connected with an electric installation carried out in compliance with the IEC-
standards. The electric installation must be equipped with a Residual Current Device (RCD) with a maximum
fault current of 30 mA.
Lighting effects must not be connected to dimming-packs.

OPERATION

After you connected the spot to the mains, the EUROLITE LED FE-800 RGBAW DMX starts running.
The LED display lights up and you can choose the desired mode via the MODE button:

- STAND ALONE-MODE

Sound Control

Automatic

- MASTER/SLAVE MODE

- DMX MODE

STAND ALONE-MODE
Sound Control
To choose Sound Control Mode (SNd), press the MODE button then press the ENTER button to confirm.
You can do without a controller as the device features a built-in microphone, which provides automatic sound
control. You can adjust the sensitivity with the rotary-control on the rearpanel.
Automatic
A chaser is a sequence of different steps that will be called up one after another in a continuous loop. In Auto
Mode the chasers are called up automatically in a continuous loop.
To choose Auto Mode (AUto), press the MODE button then press the ENTER button to confirm.
To select the uto speed press the Mode button until the display shows "s—".
The desired speed values can be selected via the UP or DOWN buttons. ( s001 - s100 decreasing).
Press the ENTER button to confirm.
MASTER/SLAVE MODE
Choose the device which will serve as Master. Press the MODE button to choose the Sound Control (SNd)
or the Auto Mode (AUto), then press the ENTER button to confirm.
To set the Slave devices, set the DMX address to d1.
DMX MODE
The Control Board allows you to assign the DMX fixture address, which is defined as the first channel from
which the LED FE-800 RGBAW DMX will respond to the controller.
Addressing
Press the MODE button until the display shows 512 and press the ENTER button to confirm.
Set the desired address via the UP or DOWN buttons, then press the ENTER button to confirm.
19/22 00056669.DOC, Version 1.3