Mains Connection; Mounting Of The Extension Cable - ATIKA BVT 2500 Bedienungsanleitung

S
S
Check that the machine is completely and correctly
assembled.
Before using the shredder, make sure each time that
there are no faulty connections (tears, cuts, etc.)
−
there are no damage at the machine
−
all screws are tight
−

Mains connection

Compare the voltage given on the machine model plate
e.g. 230 V with the mains voltage and connect the
machine to the relevant and properly earthed plug.
Only use connection cables with sufficient diameters.
Do not use any defective connection cables.
Connect the machine via a 30 mA fault current safety
switch.
Use connecting or extension cables up to a length of 1.5
m featuring a core cross section of at least 25 mm²
Fuse protection: 10 A

Mounting of the extension cable

1. Plug the female connector of the
extension cable on the male connector
of the device.
2. Thread the extension cable through
the pull relief device as a loop and
hang it up.
3. Make sure that the extension cable
has enough free motion.
Switch on
Do not use any device where the switch can not be
switched on and off. Damaged switches must be repaired
or replaced immediately by the customer service.
11
5
t a r t - u p
t a r t - u p
6
Before commencing work, ensure the following:
The machine may only be operated by persons over the
age of 16 years, and who have read and understood these
operating instructions.
Wear your safety gear (goggles/vizor, gloves) for
protection from possible injuries.
Make sure to have a safe and tidied up work area.
Remove from the working area objects which might be
thrown off.
Before starting your work make sure that:
− no other persons or animals stay within the working
area,
− you can always step back without any barriers,
− you have always a secure standing position.
Never aim the suction/blowing pipe at people or animals.
Never blow objects in the direction of people of animals.
Spectators must observe safety clearance of min. 5 m.
Beware of swirling and flying objects. Be particularly
aware of recoiling effects from brickwork or house walls
(e.g. stones).
Do not operate the machine with wet hands or during
damp weather.
Always ensure that the connection lead runs back away
from the machine. Otherwise there is a risk of stumbling,
slipping or falling.
Never use the machine
− without the bag,
− without closing the zip fastener of the bag
If persons who have blood circulation problems are too
often exposed to vibrations damages to the nervous system
or to blood vessels may occur.
You can reduce vibrations
-
by thick and warm working gloves,
- shorter working time (have longer breaks).
See a doctor if your fingers swell, you don't feel well or your
fingers become numb.
W o r k i n g w i t h t h e g a
W o r k i n g w i t h t h e g a
r d e n v a c
r d e n v a c