Herunterladen Inhalt Inhalt Diese Seite drucken

Eaton 40071349396 Montage- Und Betriebsanleitung Seite 6

Inhaltsverzeichnis

Werbung

5.2 Netzanschluss
Das Netzkabel ist an den Klemmen N, L,
L ' sowie an PE anzuschließen, wobei L als
ungeschaltete Dauerversorgung der Elektronik
und L ' über einen Lichtschalter zur bedarfsab-
hängigen Schaltung der Lampe dient.
ACHTUNG!
Der PE-Anschluss dient als Funktionserde.
Er hat keine Schutzfunktion!
5.3 Leuchte komplettieren
Die Fastonstecker der Akkuleitungen auf die
Kon taktstecker auf der Leiterkarte aufstecken
– rote Leitung an +(Plus), blaue Leitung an
– (Mi nus).
WICHTIG
Für die Nachvollziehbarkeit der Batterie-
Lebens dauer bitte das Inbetriebnahme-Datum
in das auf der Batterie vorgesehene Feld
eintragen!
SV Euro 1e: Gehäuseoberteil aufsetzen und mit
den 4 Schrauben fixieren.
SV Euro 2e: LED Leiterkarten anschliessen.
Trapezförmige Abdeckung zwischen den
angeformten trapezför
Gehäuses einlegen und die 4 Schnapphaken
einrasten. Die Piktogrammscheibe(n) auf das
Leuchten gehäuse aufschnappen.
6
SV Euro 1 & SV Euro 2 ZNO2038100 A January 2017 www.eaton.com
geschaltetes Dauerlicht
switched maintained light
migen
Blöcken des
5.2 Mains connection
The mains cable should be connected to the
terminals N, L, L ' and PE terminal, where L
is an unswitched permanent connection for
the electronics and L ' is used for switching
the lamp on and off with a light switch as and
when required.
non maintained light without jumper L -L ', main-
tained light with jumper L -L '
Bereitschaftslicht ohne Brücke L -L ', Dauerlicht mit
Brücke L -L '
ATTENTION
The PE-connection serve as function earth.
It has no function of protection!
5.3 Complete luminaire
Plug the faston plugs of the battery cables to
the contact plugs on the conductor board –
red wire to + (plus), blue wire to - (minus).
IMPORTANT
To fathom batteries life please note the start-
up date on the battery in the given data field!
SV Euro 1e: Put up the top part of enclosure
and fix it with the 4 screws.
SV Euro 2e: Connect LED-strip. Put in the
trapeze shaped cover between the adjusted
trapeze shaped blocks of enclosure and snap
the 4 snap hooks. Snap the legend cover(s) on
the enclosure of the luminaire.

Werbung

Inhaltsverzeichnis
loading

Inhaltsverzeichnis