Useful Facts; Commissioning - IKA ULTRA-TURRAX Tube Drive Betriebsanleitung

6

Useful facts

Changes in viscosity and volume caused by processing of disper-
sion media may cause small fluctuations in the speed of the device.
7

Commissioning

Pay attention to the ambient conditions listed in the "Technical
Data".
Position the rotating knob (B) at the left stop before
starting up.
If these conditions are met, the unnit is ready for
service when the mains plug hab been plugges in.
Fit the tube carefully and ensure it is
properly attached.
If above procedures are not followed,
safe operation can not be guaranteed
and/or the equipment may be damaged.
Switching on
Press "Power" button (A).
Previous mode and time
settings will be displayed e.g. :
(Factory setting: -2)
Setting Timer (Changing of modi)
Switch of the device.
Minutes-mode
Press and hold "Start/STOP" button (C),
and also press the "Power" button (A).
Minutes-mode display:
The time that was previously
4 5
3 6
set will be stored, e.g.:
2
7
1 8
9
0
Note: max. 29 min., speed range upto 4000 min
Seconds-mode
Press and hold "Start/STOP" button (C),
and also press the "Power" button (A).
Seconds-mode display:
The time that was previously
set will be stored, e.g.:
Note: max. 59 sec, speed range upto 6000 min
Setting the time
Power
The time that was previously
set will be stored, e.g.:
(Factory setting: 00)
Power
.
-1
Power
-1 .
1
10
Set the tens digit Set the ones digit
using button (E). using button (D).
14
Power
Start
Stop
Start
Stop