Using The Flash - Olympus C-5050ZOOM Anleitung

USING THE FLASH

1
Set the flash mode by turning the jog dial while holding
down .
• The flash mode changes as follows and the selected mode is displayed
on the control panel (if all modes are available):
No indication (Auto-flash)
(Flash off)
2
Press the shutter button halfway.
• When the flash is ready to fire, the orange lamp lights steady.
3
Press the shutter button fully.
TIPS
Flash working range
W (max.): Approx. 0.8 m – 5.6 m (2.6 ft. – 18 ft.)
T (max.) : Approx. 0.2 m – 3.8 m (0.7 ft. – 12 ft.)
Auto-flash (No indication)
The flash fires automatically in low light or backlight conditions.
Red-eye reduction flash (
The red-eye reduction flash mode reduces this phenomenon by emitting pre-
flashes before firing the regular flash.
Fill-in flash (
The flash always fires every time the shutter button is released.
Flash off ( )
The flash does not fire even in low light conditions.
Slow synchronization
1st curtain (front curtain)
Adjusts the flash for slow shutter speeds.
2nd curtain (rear curtain)
In contrast to 1st curtain, 2nd curtain fires the flash just before the shutter
closes.
1st curtain with red-eye reduction
Adjusts the flash for slow shutter speeds, and minimizes red-eye.
(Red-eye reduction flash)
SLOW or
)
)
SLOW1
SLOW1 (factory default setting):
SLOW2:
SLOW (slow synchronization)
SLOW2 SLOW
SLOW:
(Fill-in flash)
En
En 35