Maintenance; Handling - MC Crypt ME-100 Bedienungsanleitung

Maintenance

Regularly check the technical safety of the midi controller e.g. for a damaged housing.
If you have reason to believe that the device can no longer be operated safely, disconnect it immediately and make
sure it is not unintentionally operated. remove the USB plug!
It must be assumed that safe operation is no longer possible if:
• the device shows visible damage
• the device no longer works
• the device has been stored for a long time under unfavourable conditions or
• after the device has been exposed to extraordinary stress caused by transport
Always observe the following safety instructions before cleaning or servicing the midi controller:
Live components may be exposed if covers are opened or components are removed.
The device must be disconnected from all power sources before any servicing or repair work
is carried out.
Capacitors inside the device may still carry voltage even though they have been disconnected
from all power sources.
Only qualified experts familiar with the hazards involved and the relevant regulations may
perform repairs.
The device should only be cleaned with a soft, dry cloth or brush from the outside.
Never use any aggressive cleaning agents or chemical solutions that may damage the surface of the housing.

Handling

• Never operate the device immediately after bringing it from a cold to a warm room. The resulting condensation
could destroy the device.
Allow the appliance to reach room temperature. Wait until the condensation water has evaporated.
• Remove the USB plug when you are not using the device for an extended period.
• For safety reasons, do not operate the device in thunderstorms.
• Do not listen to excessively loud music over an extended period of time. This may damage your hearing. This
especially applies when using headphones.
39