NARVI ULTRA BIG N18 Installation Und Betriebsanleitung Seite 11

GB
INSTALLATION AND USE INSTSRUCTIONS
NARVI ULTRA BIG
ELECTRICAL SAUNA STOVES
N18, N21, N24, N27, N30, N33, N36
1. THE FOLLOWING IS REQUIRED FOR INSTALLATION:
1. The sauna stove Narvi-Ultra Big
I. 2 wedge anchors to fix the sauna stove to the floor
2. Control centre C-2003
I. bulb temperature regulator / overheating protection
II. anchor screws for the control centre and bulb temperature
regulator / overheating protection
3. Use and installation instructions for the sauna stove and control centre
4. Power unit
I. anchor screws
2. BEFORE INSTALLATION
Check the following details:
- The sauna stove is the correct size (kW) for the size of the sauna (cu m).
- Table 1 shows the volumes of the sauna for the different types of saunas.
- If there are non-insulated surfaces in the sauna, for instance brick, tile or glass,
1.5 cu m must be added to the sauna volume for each square meter of wall
on the basis of which the stove effect is defined according to Table 1.
The volume values of the sauna according to Table 1 must not be exceeded
or lowered.
- The minimum height of the sauna has been defined in Table 1 as well as
the minimum distances.
- The stove can also be installed in a wall recess where the protection distances
according to Figure 1 must be considered.
ONLY ONE ELECTRICAL STOVE CAN BE INSTALLED IN THE SAUNA
- Dimensions of the sauna stove
• Width
• Depth
• Heigh
• Weight of the sauna stove without stones
• Amount of stones in the sauna stove
85 cm
48 cm
68 cm
38 kg
120 kg