Restore Factory Settings - HomeMatic HmIP-SWD Montage- Und Bedienungsanleitung

1x long red
lighting
6x long red
flashing
1x orange and
1x green lighting
(after inserting
batteries)
8

Restore factory settings

The factory settings of the device can be resto-
red. If you do this, you will lose all your settings.
To restore the factory settings of the water sensor please
proceed as follows:
Press and hold down the system button (A) for 4
•
seconds, until the LED (A) will quickly start flas-
hing orange (see figure 5).
Operation
failed or duty
cycle limit is
reached
Device
defective
Test display
Restore factory settings
Please try again (or
see „7.2 Command
not confirmed" on
page 32 or „7.3
Duty Cycle" on
page 33).
Please see your
app for error mes-
sage or contact
your retailer.
Once the test dis-
play has stopped,
you can continue
35