Nfc: Lamp Replacement (Only Dynamic Power Devices) - ergoline SUNRISE 6200 Gebrauchsanweisung

1 2
02/2018 1018625-00A
4.8.1
Each new set of lamps must be activated with the lamp card supplied. Each
lamp card can only be used once, it is then rendered invalid.
The lamp set have to be installed first, then the lamps must be activated with
the lamp card. To do so, the lamp card must be held in the middle of the
directional pad.
On the control panel:
Selection of the device function on the directional pad
Functions or settings can be activated, deactivated or changed on the directional pad.
Start screen: Welcome to Ergoline
– Enter the master code.
Professional Setup Manager (presetting mode)
– Press for 3 seconds to open the Professional Setup Manager.
Selection if data are to be transferred.
– Press the OK button
Part numbers (1) and the operational life (2) of the lamps are displayed.
– Hold the lamp card in front of the directional pad
 Hold the lamp card in front of the directional pad until 100% is reached.
The lamp card has been successfully activated when the lamp operational life is displayed as
'000:000'.
NFC: Lamp replacement
(only Dynamic Power devices)
Cleaning and maintenance
Operating instructions – 51/74