Extraneous Voltage (Error Code 1); Connection Error (Error Code 2) - Metz Kapri plus Bedienungsanleitung

6. Operation

6.6 Extraneous Voltage (Error Code 1)

The KAPRi plus resists to extraneous voltages (short time up to 100 V).
If extraneous voltages should appear in the installation the KAPRi
plus can show their polarity and the respective conductor. The posi-
tive pole of an extraneous voltage is displayed by continuous ligh-
ting, and the negative pole is displayed by flashing of the respective
conductor LED (F).
If an extraneous voltage is detected in an installation the test run is
finished. To test this line on installation errors shut off the extrane-
ous voltage and start a new test run.
The error code for extraneous voltage is digit 1.

6.7 Connection Error (Error Code 2)

If the conductors are not interconnected (short circuit) and the
KAPRi plus Test Box is not linked the KAPRi plus Mainframe
displays a connection error. In this case either the KAPRi plus Test
Box or the KAPRi plus Mainframe are not plugged in at all or plug-
ged into the wrong jack.
The error code for connection errors is digit 2.
E12