Line Identification; Selection Of Contact Assignment - Metz Kapri plus Bedienungsanleitung

6. Operation

6.4 Line Identification

The KAPRi plus Mainframe recognizes up to nine different KAPRi
plus Test Boxes. This feature allows the user to run installation tests
and line identifications at nine different lines in one operation.
Turn on the KAPRi plus and press the Step Key (H). The numeric
display shows the Test Box number as a flashing digit (B). If a flas-
hing bar appears instead, the KAPRi plus Mainframe did not recog-
nize the number of the KAPRi plus Test Box.

6.5 Selection of Contact Assignment

Not all installations use shielded 8 conductor cables. Therefore the
KAPRi plus Mainframe offers the possibility to separate unused
contacts for the test. Contact assignment can be adjusted with the
Selection Switches (C).
Selection Switches 1 to 9
Adjust the nine Selection Switches after removing the protective
cover. Switch 1 to 8 stand for conductors 1 to 8, switch 9 stands for
the shield of the termination.
Note
Make sure that at least one conductor with an even and one with
an odd number are selected, i. e. conductor 4 and conductor 5.
E11
Switch set "ON"
means the
corresponding
wire has been
connected.