Application Controlfix; Contents Of Delivery - Kessel Staufix SWA Anleitung Für Einbau, Bedienung Und Wartung

Dear Customer,
Before installing and commissioning this
KESSEL Staufix SWA or Controlfix , please
thoroughly read through this manual and
follow all instructions!
Please make sure that nothing was dama-
ged during the shipment of this item. In case
damage did occur during the shipment plea-
se go to Section 5 - Guarantee
1.1 Application of the Staufix SWA
The KESSEL Staufix SWA backwater valve is
designed to be installed in wastewater draina-
ge pipes with or without raw sewage. The
backwater valve prevents wastewater from
backing up the drainage pipe during backwater
/ flooding. The SWA should be kept in good
operating condition and should be accessible
at all times. During normal conditions the back-
water flap is in the vertical, free handing posi-
tion. Wastewater draining out of the building
pushes the flap open and is allowed to flow
2017/02
1. General
through the SWA and out of the building. The
SWA is equipped with a manual flap locking
valve which can be used to fully lock the flap
shut – allowing no wastewater in either direc-
tion to pass through the valve. In the case that
the drainage pipes connected to the Staufix
SWA will not be used over extended periods of
time it is recommended that the flap is securely
locked with the locking lever. Important is that
when the wastewater pipes return to service
that the flap is unlocked. DIN EN 12056 and
DIN EN 13564 should be followed which regu-
lated the drainage of building and use of back-
water valves.

1.2 Application Controlfix

The KESSEL Controlfix serves as the body
housing for all KESSEL Staufix and Pumpfix
series backwater valves. The following instal-
lation instructions should be heeded. Since the
KESSEL Controlfix serves as a cleanout or
access to the drainage piping, the Controlfix
does not contain any backwater flaps and thus
19
does not offer any protection against backwa-
ter. Upgrade packages are available that can
be used to upgrade the Controlfix to any KESSEL
Staufix or Pumpfix backwater valves.

1.3 Contents of Delivery

The Staufix SWA delivery consists of a body /
housing with cover including the emergency
closure lever (closure lever not included with a
Controlfix ), and installation and operating ma-
nual (Article Number 010-841) and a see-thru
test funnel used for testing the valve after in-
stallation (test funnel not included with a
Controlfix ).
010-841