Use Additional Wireless Sensors - ADE ws 1704 Bedienungsanleitung

− Place or hang the outdoor sensor at a position where
it is protected from the direct influence of the weather
(rain, sun, wind, etc.). Suitable locations are, for
example, under an awning or in a carport.

Use additional wireless sensors

The base station is supplied with a wireless sensor.
However, you can operate it with up to three outdoor
sensors.
For more information or priced order please use the
following email address: service@ade-germany.de.
‚ The outdoor sensors can be situated in different
spaces or outdoors.
‚ Every sensor must be allocated its own number
(= no. of the transmission channel).
Procedure:
1. Place the base station and wireless sensors close
together.
2. Remove the battery compartment cover on the rear
side of the outdoor sensor.
3. For each outdoor sensor, set a unique channel using
the switches. Sensor included in delivery uses by
default channel 1, so select channel 2 for the second
and channel 3 for the third sensor.
4. Insert two batteries of the type indicated on the base.
Pay attention to the correct polarity (+/-).
5. Put the battery compartment cover back in place.
Weather Station with Wireless Outdoor Sensor WS 1704
69